OptiPlex 5090 Micro Form Factor Service Manual

PDF

Removing optional I/O modules (Type C/HDMI/VGA/DP/Serial)

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the side cover.

About this task

The following images indicate the location of the optional I/O modules and provide a visual representation of the removal procedure.

Steps

  1. Remove the two (M3X3) screws that secure the optional I/O module to the computer chassis.
  2. Disconnect the I/O-module cable from the connector on the system board.
  3. Remove the I/O module from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\