OptiPlex 5090 Micro Form Factor Service Manual

PDF

Removing the fan assembly

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the side cover.

About this task

The following images indicate the location of the fan assembly and provide a visual representation of the removal procedure.

Image: Removing the fan assembly

Steps

  1. Unroute the speaker cable from the routing guide on the fan assembly.
  2. Press the blue tabs on both sides of the fan, and slide to lift the fan to release it from the system.
  3. Turn the fan assembly over.
  4. Disconnect the fan cable from the connector on the system board. Lift the fan assembly out of the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\