OptiPlex 5090 Micro Form Factor Service Manual

PDF

Removing the hard-drive assembly

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the side cover.

About this task

The following images indicate the location of the hard-drive assembly and provide a visual representation of the removal procedure.

Image: Removing the hard drive assembly

Steps

  1. Press the release tabs on the hard-drive assembly and slide it towards the front of the system to disconnect it from the connector on the system board.
  2. Lift the hard drive assembly from the system.
    NOTE:Note the orientation of the hard drive so that you can replace it correctly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\