OptiPlex 5090 Micro Form Factor Service Manual

PDF

Screw List

The following table shows the screw list and the image of the screws.

NOTE:When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.
NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when replacing a component.
NOTE:Screw color may vary with the configuration ordered.
NOTE:As the VGA cables screw is installed or removed from the back of the computer, the VGA cables may use a hex nut.
Table 1. Screw listThe following table shows the screw list and the images for different components/locations.
Component Screw type Quantity Image

Side cover

#6-32 (Captive screws)

1

#6.32x9.3

System board

#6-32

M2x4

3

4

#6.32x5.4

#6.32x3.8

Hard drive caddy support

#6-32

1 #6.32x5.4
Heat sink M3x25 (Captive screws) 3

WLAN card

M2x3.5

1

M3x3.5

M.2 2230/2280 Solid-state drive

M2x3.5

1

M3x3.5

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\