Dell 14 Plus 2-in-1 DB04255 Owner's Manual

PDF

Connecting the battery cable

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the battery cable and provides a visual representation of connecting the battery cable.
Figure 1. Connecting the battery cable
Image: Connecting the battery cable

Steps

  1. Connect the battery cable to the connector on the battery and close the latch.
  2. Route the battery cable through the routing guides on the battery.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\