Dell 14 Plus 2-in-1 DB04255 Owner's Manual

PDF

Disconnecting the battery cable

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.

About this task

CAUTION:Removing the battery resets the BIOS setup settings to default. It is recommended that you note the BIOS setup settings before removing the battery.

The following image indicates the location of the battery cable and provides a visual representation of disconnecting the battery cable.

Figure 1. Disconnecting the battery cable
Image: Disconnecting the battery cable

Steps

  1. Open the latch and disconnect the battery cable from the connector on the battery.
    CAUTION:DO NOT pull the battery cable to disconnect it from the battery, it may damage the battery or the battery cable.
    NOTE:To disconnect the battery cable, first push the latch downward to release the connector, and then pull the connector upward to disconnect it from the battery.
  2. Unroute the battery cable from the routing guides on the battery.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\