Dell 14 Plus 2-in-1 DB04255 Owner's Manual

PDF

Installing the display assembly

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the display assembly and provide a visual representation of the installation procedure.
Figure 1. Display assembly
Display assembly
Figure 2. Installing the display assembly
Image: Installing the display assembly
Figure 3. Connecting the display cable
Image: Connecting the display cable

Steps

  1. Place the display assembly on a clean and flat surface.
  2. Place the palm-rest and keyboard assembly on the display assembly.
  3. Align the screw holes on the right display hinge with the screw holes on the palm-rest and keyboard assembly.
  4. Replace the two screws (M2.5x4) that secure the right display hinge to the palm-rest and keyboard assembly.
  5. Gently press to lower the hinges and align the screw holes on the hinges with the screw holes on the palm-rest and keyboard assembly.
  6. Replace the three screws (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
  7. Connect the display cable to the display-cable connector (LCD) on the system board and close the latch.
  8. Adhere the tape that secures the display-cable connector latch to the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\