Dell 14 Plus 2-in-1 DB04255 Owner's Manual

PDF

Installing the heat sink

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image indicates the location of the heat sink and provides a visual representation of the installation procedure.
Figure 1. Installing the heat sink
Image: Installing the heat sink

Steps

  1. Place the heat sink on the system board.
  2. Align the screw holes on the heat sink with the screw holes on the system board.
  3. In sequential order (1>2>3>4) tighten the four captive screws that secure the heat sink to the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\