Dell 14 Plus 2-in-1 DB04255 Owner's Manual

PDF

Installing the power button with fingerprint reader

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the power button with fingerprint reader and provides a visual representation of the installation procedure.

Figure 1. Installing the power button with fingerprint reader
Image: Installing the power-button with fingerprint reader

Steps

  1. Align and place the power button, along with the fingerprint-reader cable, into its slot on the palm-rest and keyboard assembly.
  2. Align the screw hole on the power button with the screw hole on the palm-rest and keyboard assembly.
  3. Replace the screw (M2x3) that secures the power button to the palm-rest and keyboard assembly.
  4. Adhere the fingerprint reader cable to the palm-rest and keyboard assembly.
  5. Close the mylar sheet.

Next steps

  1. Install the I/O-board cable.
  2. Install the I/O board.
  3. Install the base cover.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\