Dell 14 Plus 2-in-1 DB04255 Owner's Manual

PDF

Installing the speakers

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
Figure 1. Installing the speakers
Image: Installing the speakers

Steps

  1. Using the alignment posts and rubber grommets, place the speakers on the slots of the palm-rest and keyboard assembly.
    NOTE:Ensure that the rubber grommets on the speakers are threaded through the alignment posts and the four rubber grommets are seated into the slot and installed on the speakers properly.
  2. Route the speaker and wireless module cables through the routing guides on the palm-rest and keyboard assembly.
  3. Connect the speaker cable to the speaker-cable connector (SPK) on the system board.
  4. Connect the touchpad cable to the touchpad-cable connector (TP) on the system board and close the latch.
  5. Connect the keyboard cable to the keyboard-cable connector (KB) on the system board and close the latch.
  6. Connect the keyboard-backlight cable to the keyboard-backlight cable connector (KBBL) on the system board and close the latch.

Next steps

  1. Install the wireless card.
  2. Install the battery.
  3. Install the base cover.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\