Dell 14 Plus 2-in-1 DB04255 Owner's Manual

PDF

Removing the M.2 2230 solid-state drive

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

NOTE:The support card configuration on the M.2 card slot is:
  • M.2 2230 solid-state drive + M.2 2230 solid-state drive mounting bracket

The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal procedure.

Figure 1. Removing the solid-state drive
Image: Removing the solid-state drive

Steps

  1. Remove the screw (M2x3) that secures the M.2 2230 solid-state drive assembly to the system board.
  2. Slide and lift the M.2 2230 solid-state drive assembly off the system board.
  3. Flip over the M.2 2230 solid-state drive assembly.
  4. Remove the screw (M2x1.8) that secures the M.2 2230 solid-state drive to the M.2 2230 solid-state drive mounting bracket.
  5. Lift the M.2 2230 solid-state drive off the M.2 2230 solid-state drive mounting bracket.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\