Dell 14 Plus 2-in-1 DB04255 Owner's Manual

PDF

Removing the palm-rest assembly

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the wireless card.
  5. Remove the M.2 2230 solid state drive.
  6. Remove the speakers.
  7. Remove the system fan.
  8. Remove the I/O-board and I/O-board cable.
  9. Remove the power button with fingerprint reader.
  10. Remove the USB Type-C bracket.
  11. Remove the touchpad.
  12. Remove the display assembly.
  13. Remove the system board.
    NOTE:The system board can be removed with the heat sink attached.

About this task

The following image indicates the location of the palm-rest assembly and provides a visual representation of the removal procedure.
Figure 1. Removing the palm-rest assembly
Image: Removing the palm-rest assembly

Steps

After performing the steps in the pre-requisites, you are left with the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\