Dell 14 Plus 2-in-1 DB04255 Owner's Manual

PDF

Removing the USB Type-C bracket

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

The following image indicates the location of the USB Type-C bracket and provides a visual representation of the removal procedure.
Figure 1. Removing the USB Type-C bracket
Removing the USB Type-C bracket

Steps

  1. Remove the three screws (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
  2. Pry open the left display hinge to an angle of 90 degrees.
  3. Remove the two screws (M2x4) that secure the USB Type-C bracket to the palm-rest and keyboard assembly.
  4. Lift the USB Type-C bracket off the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\