Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

radius-server timeout

Configures the timeout used to resend RADIUS authentication requests.

Syntax
radius-server timeout seconds
Parameters
seconds — Enter the time in seconds for retransmission, from 1 to 100.
Default
An OS10 switch stops sending RADIUS authentication requests after five seconds.
Command Mode
CONFIGURATION
Usage Information
Use this command to globally configure the timeout value used on RADIUS servers.

Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0E(R3S). Also supported in SmartFabric mode starting in release 10.5.0.1.

The no version of this command resets the value to the default.
Example
OS10(config)# radius-server timeout 90
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\