Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

seq deny ip

Assigns a sequence number to deny IPv4 addresses while creating the filter.

Syntax
seq sequence-number deny ip [A.B.C.D | A.B.C.D/x | any | host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count | dscp value | fragment | log]
Parameters
  • sequence-number — Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214.
  • A.B.C.D — Enter the IPv4 address in dotted decimal format.
  • A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
  • any — (Optional) Enter the keyword any to specify any source or destination IP address.
  • host ip-address — (Optional) Enter the IPv4 address to use a host address only.
  • capture — (Optional) Capture packets the filter processes.
  • count — (Optional) Count packets the filter processes.
  • byte — (Optional) Count bytes the filter processes.
  • dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
  • fragment — (Optional) Use ACLs to control packet fragments.
  • log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default
Not configured
Command Mode
IPV4-ACL
Usage Information

OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.

Example
OS10(config)# ip access-list egress
OS10(config-ipv4-acl)# seq 10 deny ip any any capture session 1 log
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\