Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

timers throttle lsa all

Configures the LSA transmit intervals.

Syntax
timers lsa all [start-interval | hold-interval | max-interval]
Parameters
  • start-interval — Sets the minimum interval between initial sending and re-sending the same LSA in milliseconds, from 0 to 600,000.
  • hold-interval — Sets the next interval to send the same LSA in milliseconds. This is the time between sending the same LSA after the start-interval is attempted, from 1 to 600,000.
  • max-interval — Sets the maximum amount of time the system waits before sending the LSA in milliseconds, from 1 to 600,000.
.
Default
  • start-interval — 0 milliseconds
  • hold-interval — 5000 milliseconds
  • max-interval — 5000 milliseconds
Command Mode
ROUTER-OSPF
Usage Information
The no version of this command removes the LSA transmit timer.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# timers throttle lsa all 100 300 1000 
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\