
VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2
nve-controller
Assigns the interfaces to be managed by the controller.
- Syntax
- nve-controller
- Parameters
- None
- Default
- None
- Command mode
- INTERFACE
- Usage information
- The interface must be in Switchport Trunk mode when adding the interface to the controller. If the interface is not in the Switchport Trunk mode, the system displays the following error message:
% Error: Interface ethernet1/1/1, must be in switchport trunk for controller mode.
NOTE:If the interface has active port-scoped VLAN (Port,VLAN) pairs configured by the controller, you cannot remove an interface from the controller.The no version of this command removes the interface from the controller and removes any VXLAN binding associated with the interface.
- Example
OS10(config)# interface ethernet 1/1/1 OS10(config-if-eth1/1/1)# nve-controller
- Supported releases
- 10.4.3.0 or later
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\