
VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2
show interface virtual-network
Displays the configuration of virtual-network router interfaces and packet statistics.
- Syntax
- show interface virtual-network [vn-id]
- Parameters
- vn-id
- Enter a virtual-network ID, from 1 to 65535.
- Default
- Not configured
- Command mode
- EXEC
- Usage information
- Use this command to display the virtual-network IP address used for routing traffic in a virtual network. Traffic counters also display.
- Example
show interface virtual-network 102 Virtual-network 102 is up, line protocol is up Address is 14:18:77:25:6f:84, Current address is 14:18:77:25:6f:84 Interface index is 66 Internet address is 12.12.12.2/24 Mode of IPv4 Address Assignment: MANUAL Interface IPv6 oper status: Enabled Link local IPv6 address: fe80::1618:77ff:fe25:6eb9/64 MTU 1532 bytes, IP MTU 1500 bytes ARP type: ARPA, ARP Timeout: 60 Last clearing of "show interface" counters: 10:24:21 Queuing strategy: fifo Input statistics: 89 packets, 10056 octets Output statistics: 207 packets, 7376 octets Time since last interface status change: 10:23:21- Supported releases
- 10.4.3.0 or later
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\