Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the expansion card risers

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. If removed, install the expansion cards into the expansion card risers.

Steps

  1. For Riser 1, release the blue latch and holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
    Figure 1. Installing the Riser 1
    This image shows how to install the low profile left riser.
  2. For Riser 2c, release the blue latch and holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
    Figure 2. Installing the Riser 2c
    This image shows how to install the low profile right riser.

Next steps

  1. Replace the air shroud.
  2. Follow the procedure listed in After working inside your system.
  3. Install any device drivers required for the card as described in the documentation for the card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\