Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the intrusion switch

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.

Steps

  1. Align and insert the intrusion switch module until it is firmly seated in the slot on the system.
  2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
  3. Connect the intrusion switch cable to the connector on the system board.
    NOTE:Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
    Figure 1. Installing the intrusion switch
    This image shows how to install the intrusion switch.

Next steps

  1. Replace the air shroud.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\