Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the left control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the front bezel.
  4. Remove the backplane cover.
  5. Remove the air shroud.

Steps

  1. Route the control panel cable through the cable clip, the guide slots in the system and connector on system board.
    NOTE:Route the cable properly to prevent the cable from being pinched or crimped.
  2. Close and secure the cable guiding latch.
  3. Align and insert the left control panel assembly in the slot on the system.
  4. Using the Phillips #1 screwdriver, tighten the screws that secure the left control panel assembly to the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the left control panel
    This image shows how to install the left control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\