Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the M2 BOSS card into the M.2 BOSS riser

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the M.2 BOSS riser.

Steps

  1. Align and insert the M.2 BOSS card connector with the connectors on the M.2 BOSS riser.
  2. Press the blue touch point on the M.2 BOSS card until it is firmly seated.
    Figure 1. Installing the M2 BOSS card into the M.2 BOSS riser
    This image shows installing an expansion card into a low profile left riser.

Next steps

  1. If applicable, install the M.2 BOSS riser.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\