Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the M.2 BOSS riser

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align the M.2 BOSS riser connector with the connectors on the system board and the guide on the M.2 BOSS riser with the guiding slot on the system board.
  2. Lower the M.2 BOSS riser into place until the M.2 BOSS riser connector is fully seated in the connector.
    Figure 1. Installing the M.2 boss riser
    The image shows installing the M.2 boss module

Next steps

Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\