Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the M.2 BOSS riser.
  4. Remove the M.2 BOSS card from the M.2 BOSS riser.

Steps

  1. Align the M.2 SSD module at angle with the connector on the M.2 BOSS card.
  2. Insert the M.2 SSD module until it is firmly seated in M.2 BOSS card connector.
  3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the M.2 BOSS card with the screw.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the M.2 SSD module
    This image shows installing the M.2 BOSS card

Next steps

  1. If applicable, install the M.2 BOSS card into the M.2 BOSS riser.
  2. If applicable, Install the M.2 BOSS riser.
  3. Follow the procedure listed in the After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\