Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the OCP card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the expansion card riser.

Steps

  1. Open the blue latch on the system board.
  2. Slide the OCP card into the slot in the system.
  3. Push until the OCP card is connected to the connector on the system board.
  4. Close the latch to lock the OCP card to the system.
    Figure 1. Installing the OCP card
    This image shows how to install the OCP card.

Next steps

  1. Install the expansion card riser.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\