Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the front bezel.
  4. Remove the backplane cover.
  5. Remove the air shroud.

Steps

  1. Route the control panel cable through the latch, side wall of the system, and then slide the cable into the clip.
    NOTE:Route the cable properly to prevent the cable from being pinched or crimped.
  2. Align and insert the right control panel in the slot on the system.
  3. Connect the right control panel cable to the connector on the system board.
  4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the right control panel
    This image shows how to install the right control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\