Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the serial COM port

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Lift the expansion card rsier from the connector on the system board.

Steps

  1. Remove the screws, lift the PCIe blank, and then open the latch on the expansion card riser. (Riser 1, Riser 2c).
    Figure 1. Removing the PCIe blank
    This image shows how to Install the Serial COM port.
  2. Slide and lock the serial COM port into the expansion card riser.
  3. Connect the serial COM port cable to the serial port.
    Figure 2. Installing the Serial COM port
    This image shows how to Install the Serial COM port.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\