Dell EMC XC Core XC450 Installation and Service Manual

PDF

Installing the VGA module

Prerequisites

  1. Follow the safety guidelines in Safety instructions.
  2. Follow the safety guidelines listed in Before working inside your system.
  3. Remove the front bezel.
  4. Remove the backplane cover.
  5. Remove the air shroud.
    NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped

Steps

  1. Route the VGA cable through the VGA module slot on the front of the system and slide the VGA module into the slot.
  2. Align the hole on the module with the screw hole on the system.
  3. Using the Phillips #1 screwdriver, secure the VGA module to the system with the screw.
    Figure 1. Installing the VGA module
    This image shows how to install the VGA module.

Next steps

  1. Route the VGA cable and connect it to the VGA connector on the system board. For locating the connector, see the System board jumpers and connecters section.
  2. Replace the air shroud.
  3. Replace the backplane cover.
  4. Replace the front bezel.
  5. Follow the procedure listed in After working inside your system.
.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\