Dell EMC XC Core XC450 Installation and Service Manual

PDF

Removing a power supply unit

Prerequisites

CAUTION:The system requires one power supply unit (PSU) for normal operation. On power-redundant systems, remove and replace only one PSU at a time in a system that is powered on.
  1. Follow the safety guidelines listed in the Safety instructions.
  2. Disconnect the power cable from the power outlet and from the PSU you intend to remove.
  3. Remove the cable from the strap on the PSU handle.
  4. Unlatch and lift the optional cable management arm if it interferes with the PSU removal. For information about the cable management arm, see the system’s rack documentation at https://www.dell.com/poweredgemanuals.

Steps

Press the release latch, and holding the PSU handle slide the PSU out of the PSU bay.
Figure 1. Removing a power supply unit
Removing a power supply unit

Next steps

Replace the PSU.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\