Dell EMC XC Core XC450 Installation and Service Manual

PDF

Removing the intrusion switch module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.

Steps

  1. Disconnect and remove the intrusion switch cable from the connector on the system board.

    Observe the routing of the cable as you remove it from the system.

  2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
  3. Lift the intrusion switch module out of the system.
    Figure 1. Removing the intrusion switch module
    This image shows how to remove the intrusion switch.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\