Dell EMC XC Core XC450 Installation and Service Manual

PDF

Removing the left control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. If applicable, remove the backplane cover.

Steps

  1. Disconnect the control panel cable from the system board connector.
    NOTE:Observe the routing of the cable as you remove it from the system.
  2. Open the cable retention latch.
  3. Remove the cable from cable clip.
  4. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel assembly to the system.
  5. Hold the left control panel assembly and remove the control panel along with the cable from the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the left control panel
    This image shows how to remove the left control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\