Dell EMC XC Core XC450 Installation and Service Manual

PDF

Removing the OCP card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the expansion card riser.

Steps

  1. Open the blue latch to unlock the OCP card.
  2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
  3. Slide the OCP card out of the slot on the system.
    Figure 1. Removing the OCP card
    This image shows how to install the OCP card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\