Dell EMC XC Core XC450 Installation and Service Manual

PDF

Removing the power interposer board

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the PSU
  5. Disconnect the cables that are connected to power interposer board (PIB).

Steps

  1. Using a Phillips #2 screwdriver, remove the screws securing the power interposer board to the system.
    NOTE:Observe the routing of the cable as you remove it from the system.
  2. Lift the PIB away from the system.
    Figure 1. Removing the power interposer board
    This image shows how to remove the power interposer board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\