Dell EMC XC Core XC450 Installation and Service Manual

PDF

Removing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the front bezel.
  4. Remove the backplane cover.
  5. Remove the air shroud.

Steps

  1. Disconnect the control panel cable and the VGA cable from the system board connector and remove the cable from cable clip.
    NOTE:Observe the routing of the cable as you remove it from the system.
  2. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
  3. Hold the right control panel assembly and remove the control panel along with the cable from the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the right control panel

    This image shows how to remove the right control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\