Dell EMC XC Core XC450 Installation and Service Manual

PDF

Removing the VGA module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the front bezel.
  4. Remove the backplane cover.
  5. Remove the air shroud.
  6. Disconnect the VGA cable from the VGA connector on the system board. For locating the connector, see the System board jumpers and connectors section.
NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped

Steps

  1. Using Phillips #1 screwdriver, remove the screw on the VGA module.
  2. Slide the module out of the system.
    Figure 1. Removing the VGA module
    This image shows how to remove the VGA module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\