
Dell PowerEdge R7525 Installation and Service Manual
Installing a GPU
Prerequisites
WARNING:Consumer-Grade GPU should not be installed or used in the Enterprise Server products.
- Follow the safety guidelines listed in the Safety instructions.
- Follow the procedure listed in Before working inside your system.
- If installing a new expansion card, unpack it and prepare the card for installation.
NOTE:For instructions, see the documentation accompanying the card.
- Remove the GPU air shroud top cover
Steps
- Open the expansion-card latch, and remove the metal filler bracket away from the riser.
Figure 1. Removing the metal filler bracket 
- To install the GPU on Riser 1:
- Align the connector on the GPU with the connector on the riser.
- Insert the GPU into the riser until it is fully seated.
- Close the expansion card holder latch.
- Press the black card holder latch on the GPU and riser to secure the GPU card to the riser.
- Connect the GPU power cable to the GPU card.
Figure 2. Installing GPU on Riser 1 
- To install the GPU on Riser 3 and 4:
- Align the connector on the GPU with the connector on the riser.
- Insert the GPU into the riser until it is fully seated.
- Close the expansion card holder latch.
- Press the black card holder latch on the GPU and riser to secure the GPU card to the riser.
- Connect the GPU power cable to the GPU card.
- Slide back the expansion card latch on the riser.
Figure 3. Installing GPU on Riser 3 and Riser 4 
Next steps
- If removed, install the GPU air shroud .
- Install the GPU air shroud top cover.
- Install the full length expansion card riser.
- Follow the procedure listed in After working inside your system.
- Install any device drivers required for the card as described in the documentation for the card.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\