Dell PowerEdge R7525 Installation and Service Manual

PDF

Installing the 4 x 2.5-inch rear drive module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If installed, remove the expansion card risers.

Steps

  1. Align and lower the rear drive module with the guide on the system board.
  2. Using a Phillips #2 screwdriver, tighten the captive screws that secures the rear drive module into the system.
    Figure 1. Installing the 4 x 2.5-inch rear drive module
    This image shows Installing the 4 x 2.5-inch rear drive module

Next steps

  1. Connect all the cables to the rear drive module.
  2. Install the drives.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\