Dell PowerEdge R7525 Installation and Service Manual

PDF

Installing the cooling fan cage assembly

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
    CAUTION: Ensure that the cables inside the system are correctly installed and retained by the cable retention bracket before installing the cooling fan cage assembly. Incorrectly installed cables may get damaged.
  2. Follow the procedure listed in Before working inside your system.
  3. If installed, remove the air shroud.

Steps

  1. Align the guide rails on the cooling fan cage assembly with the standoffs on the system.
  2. Lower the cooling fan cage assembly into the system until the cooling fan cage connectors engage with the connectors on the system board.
  3. Press the release levers to lock the cooling fan cage assembly into the system.
    Figure 1. Installing the cooling fan cage assembly

    This image shows Installing the cooling fan assembly.

Next steps

  1. If removed, install the air shroud.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\