Dell PowerEdge R7525 Installation and Service Manual

PDF

Installing the intrusion switch module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the expansion card riser.
NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped

Steps

  1. Align the guides on the intrusion switch module with the standoffs on the system.
  2. Slide the intrusion switch module into the slot in the system until firmly seated.
  3. Using a Phillips #2 screwdriver, tighten the screw on the intrusion switch module.
  4. Connect the intrusion switch cable to the connector on the rear I/O board.
    Figure 1. Installing the intrusion switch module

    This image shows Installing the intrusion switch module.

Next steps

  1. Install the expansion card riser.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\