Dell PowerEdge R7525 Installation and Service Manual

PDF

Installing the left control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align and slide the left control panel in the slot on the system.
  2. Connect the left control panel cable to the connector on the system board .
  3. Route the left control panel cable through the side wall of the system. Align and slide the left control panel cable cover in the slot on the system.
    NOTE:Route the cable properly to prevent the cable from being pinched or crimped.
  4. Using the Phillips #1 screwdriver, tighten the screws to secure the left control panel and the left control panel cable cover to the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the left control panel

    This image shows Installing the left control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\