Dell PowerEdge R7525 Installation and Service Manual

PDF

Installing the LOM card and rear I/O board

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the system board.

Steps

  1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
  2. Press the LOM card or rear I/O board until firmly seated on the system board connector.
  3. Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
    Figure 1. Installing the LOM card and rear I/O board
    This image shows installing the LOM card and rear I/O board.

Next steps

  1. Install the system board.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\