Dell PowerEdge R7525 Installation and Service Manual

PDF

Installing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the BOSS card. Removing BOSS card is similar to removing expansion card from the expansion card riser.

Steps

  1. Align the M.2 SSD module at an angle with the BOSS card connector.
  2. Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
  3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
    Figure 1. Installing the M.2 SSD module
    This image shows how to install the M.2 SSD module.

Next steps

  1. Install the BOSS card. Installing the BOSS is similar to installing expansion card into the expansion card riser.
  2. Follow the procedure listed in the After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\