Dell PowerEdge R7525 Installation and Service Manual

PDF

Installing the OCP card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the expansion card riser.

Steps

  1. If installed, remove the filler bracket.
    Figure 1. Removal of filler bracket

    This image shows Removal of filler bracket.

  2. Open the blue latch on the system board.
  3. Slide the OCP card into the slot in the system.
  4. Push until the OCP card is connected to the connector on the system board.
  5. Close the latch to lock the OCP card to the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 2. Installing the OCP card

    This image shows Installing the OCP card.

Next steps

  1. Install the expansion card riser
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\