Dell PowerEdge R7525 Installation and Service Manual

PDF

Installing the rear drive cage

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align the guide and slot on the rear drive module with the slot and guide on the system.
  2. Insert the rear drive module on top of the Riser 2a.
  3. Tighten the captive screws to secure the rear drive cage to the system.
    Figure 1. Installing the rear drive cage

    This image shows Installing the rear drive cage.

Next steps

  1. Replace the expansion card riser, if needed.
  2. Connect all the cables to the rear drive cage.
  3. Install all the drives.
  4. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\