Dell PowerEdge R7525 Installation and Service Manual
Installing the side wall bracket
Prerequisites
- Follow the safety guidelines listed in the Safety instructions.
- Follow the procedure listed in the Before working inside your system.
- If installed, remove the front bezel.
- Remove the backplane cover.
- If installed, remove the air shroud.
NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
- Align the side wall bracket with the tabs on the chassis.
- Press the side wall bracket with your thumbs until the bracket firmly clicks into place.
NOTE:Route the cables through the side wall bracket.
- Close the side wall bracket cover with your thumbs until the cover firmly clicks into place.
Figure 1. Installing the side wall bracket 
Next steps
- Replace the cooling fan assembly.
- If removed, install the air shroud.
- Install the backplane cover.
- If installed, install the front bezel.
- Follow the procedure listed in the After working inside your system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\