Dell PowerEdge R7525 Installation and Service Manual

PDF

Removing a memory module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. If installed, remove the air shroud.
WARNING:The memory modules are hot to touch for some time after the system has been powered off. Allow the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components or metallic contacts on the memory module.

Steps

  1. Locate the appropriate memory module socket.
  2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module socket.
    CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memory module or metallic contacts.
  3. Lift the memory module away from the system.
    Figure 1. Removing a memory module
    This image shows how to remove a memory module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\