Dell PowerEdge R7525 Installation and Service Manual

PDF

Removing the 4 x 2.5-inch rear drive module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove all the drives.
  4. NOTE:If the BOSS S2 module is installed, ensure to disconnect the BOSS S2 power cable and Signal cable before removing the 4 x 2.5-inch rear drive module.
    Figure 1. Removing the BOSS S2 power cable and signal cable
    Removing the BOSS power cable and BOSS signal cable from the BOSS S2 controller card module
  5. Disconnect the cables from the rear drive module.
    NOTE:Refer cable routing topic for more information.

Steps

  1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the rear drive module to the system.
  2. Lift the rear drive module from the system.
    Figure 2. Removing the 4 x 2.5-inch rear drive module
    This image shows Removing the 4 x 2.5-inch rear drive module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\