Dell PowerEdge R7525 Installation and Service Manual

PDF

Removing the intrusion switch module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the expansion card riser.
NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped

Steps

  1. Disconnect the intrusion switch cable from the connector on the rear I/O board.
  2. Using a Phillips #2 screwdriver, loosen the screw on the intrusion switch module.
  3. Slide the intrusion switch module out of the slot on the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the intrusion switch module

    This image shows Removing the intrusion switch module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\