Dell PowerEdge R7525 Installation and Service Manual

PDF

Removing the left control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the drive backplane cover.
  4. If installed, remove the air shroud.
  5. Remove the cooling fan assembly.
  6. Remove the side wall bracket.

Steps

  1. Disconnect the control panel cable from the connector on the system board.
  2. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel and the left control panels cable cover to the system.
  3. Hold the left control panel cable, and slide the left control panel out of the system.
    NOTE:Observe the routing of the cable as you remove the right control panel from the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the left control panel

    This image shows Removing the right control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\