Dell PowerEdge R7525 Installation and Service Manual

PDF

Removing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the BOSS card. The BOSS card removal is similar to removing expansion card from the expansion card riser.

Steps

  1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
  2. Pull the M.2 SSD module to disconnect from the BOSS card connector.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the M.2 SSD module
    This image shows how to remove the M.2 SSD module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\